Enabling FIPS 140 Mode and Checking for Compliance
1.
In CentreWare Internet Services, click Properties > Security > Encryption.
2.
Click FIPS 140-2.
3.
Click Enable.
Click Run Configuration Check and Apply.
4.
A pass or fail message appears:
If the configuration check passes, click Reboot Machine to save and restart the printer.
If the configuration check fails, the reasons for the failed test list in a table at the bottom of the
page. For each reason, a link is provided. Click the appropriate link to disable the protocol,
replace the certificate, or allow the printer to use the non-compliant protocol.
Note:
When FIPS 140 Mode is enabled, only FIPS-compliant certificates can be installed on the
printer.
ColorQube 8700/8900 Color Multifunction Printer
System Administrator Guide
Security
77