Kyocera TASKalfa 620 Service Manual page 97

Maintenance
item No.
Checking the operation of the finisher
U240
Description
Turns each motor and solenoid of the document finisher ON.
Purpose
To check the operation of each motor and solenoid of the document finisher.
Method
1. Press the start key. The screen for selecting an item is displayed.
2. Select the item to be checked.
Display
FINISHER
SADDLE
Method: Checking the motor and solenoid of the document finisher
1. Select FINISHER at the screen for selecting an item.
2. Select the item to be operated.
Display
FD_IN_MT_H
FD_IN_MT_M
FD_IN_MT_L
CNV_MT_H
CNV_MT_M
CNV_MT_L
UP_MT
DOWN_MT
LGR_TEST
A3_TEST
WDTH_MT_L
SLAP_MT_INI
SLAP_MT_MOV
DRM_MT_H
DRM_MT_M
DRM_MT_L
EJECT_MT_H
EJECT_MT_M
EJECT_MT_L
MTRAY_MT
JTRAY_MT
SOL_A
SOL_B
SOL_C
COLO_SOL
LOCK_SOL
P_PUT_SOL
EJECT_SOL
PUNCH_MT
PUNCH_SOL
Description
Description
Motors and solenoids of document finisher
Motors and solenoids of centerfold unit
Motors and solenoids
Paper entry motor (PEM) is turned on high speed
Paper entry motor (PEM) is turned on middle speed
Paper entry motor (PEM) is turned on low speed
Paper conveying motor (PCM) is turned on high speed
Paper conveying motor (PCM) is turned on middle speed
Paper conveying motor (PCM) is turned on low speed
Upper paper conveying belt motor (PCBM-U) is turned on
Lower paper conveying belt motor (PCBM-L) is turned on
Front/rear upper side registration guide motor (SRGM-FU/RU) test
operation for 11" x 17" size
Front/rear upper side registration guide motor (SRGM-FU/RU) test
operation for A3 size
Lower side registration guide motor (SRGM-L) is turned on
Movable guide motor (MGM) is turned on initial driving
Movable guide motor (MGM) is turned on
Siding drum motor (SDM) is turned high speed
Siding drum motor (SDM) is turned middle speed
Siding drum motor (SDM) is turned low speed
Eject motor (EJM) is turned on high speed
Eject motor (EJM) is turned on middle speed
Eject motor (EJM) is turned on low speed
Main tray elevation motor (MTEM) is turned on
Multi job tray elevation motor (MJTEM) is turned on
Feedshift solenoid A (FSSOLA) is turned on
Feedshift solenoid B (FSSOLB) is turned on
Feedshift solenoid C (FSSOLC) is turned on
Paper forwarding pulley solenoid (PFPSOL) is turned on
Lock solenoid (LSOL) is turned on
Paper holder solenoid (PHSOL) is turned on
Eject guide solenoid (EGSOL) is turned on
Punch motor (PUNM) is turned on
Punch solenoid (PUNSOL) is turned on
2KN/2KP
1-3-59