Detaching And Refitting The Dp Original Feed Belt, Dp Forwarding Pulley And Dp Separation Roller - Kyocera TASKalfa 620 Service Manual

(2) Detaching and refitting the DP original feed belt, DP forwarding pulley and DP separation roller

Follow the procedure below to clean or replace the DP original feed belt, DP forwarding pulley and DP separation roller.
Procedure
1. Open the document processor top cover.
2. Remove two screws and then remove the
upper original feed cover.
3. Remove the stop ring of the original feed
belt shaft front and move the bush aside to
inside.
4. Slide the original feed pulley unit to front and
release the rear of the original feed belt
shaft. Remove the original feed pulley unit
from DP.
Document processor
top cover
Figure 1-5-155
Stop ring
Figure 1-5-156
2KN/2KP
Upper original
feed cover
Original feed pulley unit
Bush
1-5-75