Kyocera TASKalfa 620 Service Manual page 229

Removing the separation pulley of cassette 2
28. Remove the separation pulley unit from the
primary paper feed unit of cassette 2.
29. Remove the separation pulley from the sep-
aration pulley unit, and then clean or replace
the pulley (see page 1-5-6).
30. Refit the separation pulley unit to the pri-
mary paper feed unit of cassette 2.
31. Refit the paper feed pulley unit to the pri-
mary paper feed unit of cassette 2.
32. Close the primary paper feed unit and insert
the joint to the paper feed pulley shaft.
33. Refit three stop rings to the primary paper
feed unit.
34. Refit the deck conveying unit.
35. When the paper feed pulley, forwarding pul-
ley or separation pulley is replaced, perform
maintenance mode U901 (clearing copy
counts by paper feed locations) (see page 1-
3-87).
Separation pulley unit
Figure 1-5-17
2KN/2KP
Primary paper feed unit
of cassette 2
1-5-9