Kyocera TASKalfa 620 Service Manual page 90

2KN/2KP-2
Maintenance
item No.
Setting the fuser control mode
U169
Description
Performs control with the fuser control temperature dropped by 5
Purpose
To modify settings if a fuser failure occurs as a result of the wear and tear of the heat roller.
Method
Press the start key. The screen for selecting an item is displayed.
Setting
1. Change the setting using the cursor up/down keys.
Setting
0
1
Initial setting: 0
2. Press the start key. The setting is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Checking the cleaning count
U180
Description
Displays the cleaning count for checking.
Purpose
To check the cleaning count after replacement of the cleaning unit.
Method
Press the start key. The cleaning count is displayed.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Setting the fuser web drive
U194
Description
Sets the interval (number of copies) for turning on the fuser web solenoid.
Purpose
To be executed when the fuser web roller becomes extremely soiled.
Method
Press the start key. The screen for adjustment is displayed.
Setting
1. Select the item to be set.
2. Change the setting using the cursor up/down keys.
Setting
COUNT
No. of Turns
When setting to the value above initial setting, replacement is needed before 500000.
3. Press the start key. The value is set.
Completion
To exit this maintenance item without changing the current value, press the stop/clear key.
The screen for selecting a maintenance item No. is displayed.
1-3-52
Description
Description
Normal fuser control temperature
Performing control with the fuser control temperature dropped by 5
while printing.
Setting
Interval for the fuser web solenoid operation 0 to 255
Number of the fuser web solenoid operation 1 to 5
° °
C/9 F while printing.
Setting range Initial setting
66 (sheets)
3
° °
C/9 F