Change Transmission/Rear Axle/Hydraulic Oil And Filters - New Holland T6010 Operator's Manual

New holland t6010; t6020; t6030; t6050; t6070 tractors
Hide thumbs Also See for T6010:
Table of Contents

Advertisement

OPERATION 25
CHANGE TRANSMISSION/REAR AXLE/
HYDRAULIC OIL AND FILTERS
Prior to changing the oil , run the engine and operate
the hydraulic system until the oil is warm. Park the
tractor on level ground, lower the three--point linkage
and stop the engine. Engage the parking brake and
chock the wheels on both sides.
WARNING
Be very careful to avoid contact with hot engine oil.
If the engine oil is extremely hot, alllow it to cool to a
moderately warm temperature before proceeding.
To change the oil:
1. Remove the drain plug (1) Figure 82 and
completely drain all oil into a suitable container.
Dispose of oil properly.
2. Re--install the drain plug after the oil has drained.
IMPORTANT: Perform operation 23 (change
hydraulic and transmission filters) before refilling
with oil.
3. Remove the filler plug cap (1) figure 83 and refill
with new oil.
4. Run the engine and operate the hydraulic
system. Fully raise the three--point linkage.
5. Stop the engine and wait five minutes while
checking the system for leaks.
6. Check the oil level by means of the sight glass
(1) figure 84. Add oil as required until the oil level
is between the 'MIN' and 'MAX' marks.
NOTE: Do not fill above the full mark
See page 4--9 for the correct oil specification.
SECTION 4 - - LUBRICATION AND MAINTENANCE
82
83
84
4--39

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

T6030T6070T6020T6050

Table of Contents