Indicator Lights; Hitch Position Display; Malfunction Warning Light - New Holland T6010 Operator's Manual

Indicator Lights

The malfunction warning light (1), serves two
purposes:
-- Flashing light means that there is a malfunction
in the system circuits. This will be accompanied by
the hitch error symbol appearing in the Dot Matrix
Display.
-- Steady light signifies 'hitch disabled'. Again, the
'hitch disabled' warning is repeated in the Dot Matrix
Display with the hitch symbol.
The indicator lights (2) and (3), operate when the
position control lever is used to raise or lower the
implement or as lift and lower corrections occur
during normal tractor operation. The lower light (3)
will illuminate when the 3--point linkage lowers. The
upper light (2) will illuminate when the linkage raises.
A slip limit 'on' indicator (4), illuminates when the
wheel slip limit control is activated.

Hitch Position Display

The digital display in the instrument panel indicates
the position of the lower links over a scale of '0' to
'100'. A display of '0' indicates that the links are fully
lowered. '100' indicates they are fully raised. Select
the display using the CAL/SEL switch or the
Enhanced keypad (where fitted).

Malfunction Warning Light

In the unlikely event that a fault occurs in the EDC,
the malfunction warning light (1) Figure 81, will start
to flash. The warning light will be accompanied by the
appearance of the hitch symbol (1), and error code
(2), in the Dot Matrix Display.
SECTION 3 - - FIELD OPERATION
81
82
83
3--49