Dimming Control; Centre Lcd; Rear Wheel Slip - New Holland T6010 Operator's Manual

SECTION 2 - - CONTROLS, INSTRUMENTS AND OPERATION

Dimming Control

The brightness of the liquid crystal (LCD) and dot
matrix displays (DMD) may be varied by using the
dimming control button (1). Momentarily depressing
the button will alter the backlighting in steps. Depress
and hold the button to cycle through the full range of
backlighting from low to high intensity. Release the
button when the required setting is obtained.

Centre LCD

The information displayed in the centre LCD, will vary
depending on tractor specification. Use the CAL/SEL
switch or Enhanced Keypad (where fitted) to toggle
between the displays.
The following information may be displayed in the
centre LCD.
1. Rear wheel slip (with radar option only)
2. Power Take Off speed (front or rear)
3. 3--point hitch position (front or rear)

Rear Wheel Slip

If your tractor is equipped with optional ground speed
radar, the percentage (%) of rear wheel slip may be
displayed. The slip figure is calculated from
information provided by the transmission speed
sensor (theoretical ground speed) and the radar (true
ground speed).
2--42
78
79
80