Height Limiter Cam - New Holland T6010 Operator's Manual

Height Limiter Cam

The height limiter cam is on the right-hand end of the
hydraulic rocker shaft. Turn the cam adjuster (1)
clockwise to decrease implement height, turn
anti--clockwise to increase implement height. The
cam adjuster is self locking and will remain in position
once set.
The cam (2) is shown in contact with the lever (3) at
the maximum height position. To achieve full lift
height, turn the cam adjuster fully anti--clockwise
until the cam is clear of the lever when the lower links
are in the fully raised position.
NOTE: The height limiter cam only affects operation
of the fast raise button. When the cam comes into
contact with the lever, it cancels the signal from the
fast raise button and stops the 3-point linkage from
raising further.
Repeat the previous step to check for implement to
cab clearance. If clearance is inadequate, move the
cam further in a clockwise direction. When clearance
is satisfactory, proceed to operate.
3--42
SECTION 3 - - FIELD OPERATION
69
70