Slider Frame With Non-Swivelling Tow Pins (Dealer Installed Accessory) - New Holland T6010 Operator's Manual

Slider Frame with non-swivelling Tow Pins
(dealer installed accessory)
The tow hitches shown are equipped with a height
adjustable, non-swivelling, tow pin assembly. The
standard tow pin is shown in Figure 172. Figure 173
shows the heavy duty tow pin.
Remove the securing clip (1) and lift the handle (5) to
the vertical position. Lifting the handle will rotate the
pins and disengage them from the notches in the
frame. Using both hands on the handle (5) lift or lower
the tow pin assembly (4), as required. When at the
required height, support the tow pin with one hand and
lower the handle to the horizontal position, as shown
in Figures 172 and 173. The pins will rotate and
re-engage the notches in the frame. Lower the P.T.O.
guard (6).
To attach a trailer drawbar to the tow pin, remove the
'R' clip (3) from the tow pin and lift out using the
handle (2). Re-insert the tow pin so that it passes
through the eye of the trailer drawbar. Replace the 'R'
clip.
NOTE: The static downward load on the tow pin must
not exceed the rear tyre load capacity or the following
values, whichever is lower. (See Tyre Pressures and
Permissible Loads at the end of Section 3).
Standard tow pin (Fig. 172)
Category D2 tow pin (Fig. 173)
SECTION 3 - - FIELD OPERATION
1500 kg (3300 lb.)
2000 kg (4400 lb.)
172
173
174
3--103