Work Lamp And Beacon Switch Panel; Beacon Power Socket - New Holland T6010 Operator's Manual

SECTION 2 - - CONTROLS, INSTRUMENTS AND OPERATION

Work Lamp and Beacon Switch Panel

NOTE: The work lamps will only operate with the
tractor lights switched on.
With Standard Cab
The switches are located on a panel mounted in the
roof console (1). Individual switches control the front
and rear work lamps and the rotating beacon (where
fitted). Depress the switches once to illuminate,
depress again to turn the lamps off.
When the key-start switch is turned on, the switches
will be internally illuminated. The light intensity will
increase as each switch is activated.
With Low Profile Cab
The worklamp and beacon switches are located on
the right--hand cab 'C' pillar. Depress the lower part
of the switch to operate the light.
1. Grab rail mounted worklamps
2. Roof beacon
3. Rear worklamps
4. Front lower worklamps (engine hood)
NOTE: Do not adjust a fender-mounted, rear work
lamp to point fully downwards. The heat generated
by the work lamp may distort the plastic housing of
the rear lamp cluster.

Beacon Power Socket

Two power sockets for the rotating beacon are
provided at the rear of the cab, one on each side.
29
30
31
2--19