Hydraulic Oil Filter - Replace; Hydraulic (Hst) Oil Filter - Replace - New Holland Boomer 45 Operator's Manual

Hydraulic oil filter - Replace

WARNING
Burn hazard!
Do not handle any service fluid (engine coolant, engine oil, hydraulic oil, etc.) at temperatures that
exceed 49 °C (120 °F). Allow fluids to cool before proceeding.
Failure to comply could result in death or serious injury.
NOTE: Replace the hydraulic system oil filter after the first
50 hours of operation, and then following every 300 hours
of operation thereafter.
The hydraulic system uses a spin-on type oil filter (1),
located on the right-hand side of the tractor underneath
the operator's platform.
To replace the filter, do the following:
1. Unscrew (A) the used oil filter and discard.
2. Coat the gasket on the new filter with a film of clean
oil. Screw (B) the filter into place until the gasket
contacts the sealing surface, then tighten the filter
by hand approximately three-quarters of a turn. Do
not overtighten.
3. Start the engine and check the filter for leaks.
4. Stop the engine and check the hydraulic system oil
level. Add oil if necessary.

Hydraulic (HST) oil filter - Replace

WARNING
Burn hazard!
Do not handle any service fluid (engine coolant, engine oil, hydraulic oil, etc.) at temperatures that
exceed 49 °C (120 °F). Allow fluids to cool before proceeding.
Failure to comply could result in death or serious injury.
NOTE: Replace the hydrostatic (HST) system oil filter after the first 50 hours of operation, and then following every
300 hours of operation thereafter.
The hydrostatic system uses a spin-on type oil filter (1),
located on the left-hand side of the tractor underneath
the operator's platform.
To replace the filter, do the following:
1. Unscrew (A) the used oil filter and discard.
2. Coat the gasket on the new filter with a film of clean
oil. Screw (B) the filter into place until the gasket
contacts the sealing surface, then tighten the filter
by hand approximately three-quarters of a turn.
NOTICE: Do not overtighten.
3. Start the engine and check the filter for leaks.
4. Stop the engine and check the hydraulic system oil
level. Add oil if necessary.
7 - MAINTENANCE
7-25
W0330B
1
NHIL16CT00455AA
W0330B
1
NHIL16CT00454AA