Programming The Displays; Programming Keys - New Holland T6010 Operator's Manual

SECTION 2 - - CONTROLS, INSTRUMENTS AND OPERATION

PROGRAMMING THE DISPLAYS

WARNING
The radar ground speed sensor, located in front of
the right-hand footsteps, emits a low intensity
microwave signal which is completely safe in normal
use. Although the signal intensity is low, do not look
directly into the face of the sensor while in operation
so as to avoid eye damage.

Programming Keys

Four keys are used to select, change or memorise
the various functions related to the performance
monitor and enhanced keypad. All programme
information will appear in the Dot Matrix Display
(DMD) along with the relevant symbol for the function
selected.
1. Menu Up/Digit Value Key. Use this key to scroll
upwards through the function menu or to
increase the value of a selected digit during a
calibration procedure. Values will increase by
one each time the key is depressed.
2. Exit/Cancel Key. Depress this key to exit the
calibration mode. The key may be used at any
time during a set--up procedure to cancel and exit
the calibration mode, however, information not
saved will be lost.
3. Menu Down/Digit Select Key. In the calibration
mode depress this key to scroll downwards
through the menu or to select a digit for
re--calibration. Each time the key is depressed
the flashing cursor showing the current digit
selected will move one space to the right.
4. Menu Enter Key. Depress this key for 3 seconds
to enter the programme mode, SETUP/MENU
will appear initially in the display. After 2 seconds
the display will change to read CAL. This will be
accompanied by the Menu Up/Down arrows and
the Menu Enter symbol.
When the appropriate function screen has been
selected, depress the Menu/Enter key again to
access the calibration mode.
2--60
106