New Holland T6010 Operator's Manual page 184

The code indicates the tractor circuit or sensor in
which the fault lies and the type of fault, e.g. short
circuit, open circuit, sensor failure, etc. In this event
your tractor will require the attention of your
authorised dealer.
A steady malfunction warning light signifies 'hitch
disabled' which is repeated in the Dot Matrix Display
by the apperance of the hitch symbol (1) and error
code '1024' (2).
The 'hitch disabled' warning light signifies that the
position control setting does not correspond to the
position of the lower links with the result that the
lower links cannot be raised or lowered using the
in-cab controls. The 'hitch disabled' warning will
display if:
The Position Control lever has been moved with
•
the engine stopped.
One of the external power lift switches has been
•
operated to raise or lower the three-point linkage.
See 'External Hydraulic Power Lift Controls' on
page 3--57.
To put the Position Control lever back into phase with
the lower links, place the raise/lower switch in the
central position and, with the engine running, move
the Position Control lever (1) slowly forward or
rearward, as required, until the position of the lever
matches the linkage height. The 'hitch disabled'
warning light will go out and the hitch error symbol will
disappear from the Dot Matrix Display. The 3--point
linkage will now raise or lower normally.
3--50
SECTION 3 - - FIELD OPERATION
84
85