Replaying A Timed Programme; Deleting Programmes; Recalling A Stored Programme; Relieving System Pressure - New Holland T6010 Operator's Manual

Replaying a Timed Programme

The timed sequence begins as soon as the lever is
placed in the extend or retract detent position. On
reaching the end of the timed period, oil flowing
through the remote valve will be halted, the remote
valve lever should now be returned to the neutral
position ready for the next operation. Throughout the
replay sequence, the green warning light will remain
illuminated.

Deleting Programmes

To delete a programme, depress the programme
switch to de--activate timer operation. The light will
extinguish and the memorised sequence will be
cleared from the programme in the memory.

Recalling a Stored Programme

With the key--start on and all remote valve levers in
neutral, hold down the timer switch for the EHR
required. Keep the timer switch depressed until the
light illuminates and remains on, the previously
stored timer sequence is now re--activated.
IMPORTANT: At key- -off (engine stop), electronic
programme settings made during tractor operation
are transferred from the operating memory to the
main memory. To provide sufficient time for the data
to transfer, allow a minimum of five seconds delay
before turning the key on again.
SECTION 3 - - FIELD OPERATION

Relieving System Pressure

WARNING
Before connecting or disconnecting hydraulic hoses
at the remote cylinders, relieve the pressure in the
circuit by first starting the engine and then move the
control levers fully forward to the "float" position.
Then stop the engine. Make sure no one will be
injured by moving equipment when relieving
pressure in the system. Before disconnecting
cylinders or equipment, make sure the equipment or
implement is supported securely.
Never work under equipment supported by a
hydraulic device because it may drop if the control is
actuated (even with the engine stopped) or in the
event of hose failure, etc. always use a secure
support for equipment which must be serviced while
in the raised position. Make sure that oil contained
within the remote cylinders is clean and is of the
correct grade.
3--77