With Twin Spool Mid Mounted Remote Valve - New Holland T6010 Operator's Manual

Ensure all EHR timer switches (1), are in the off
•
position.
Turn the key--start on, but do not start the engine.
•
Depress the timer switch for remote valve No.1
•
then, within five seconds, depress the timer
switch for valve No. 2.
'FEhr' will appear in the Dot Matrix Display, after
•
two seconds this will change to show the current
default valve, for example 'Ehr4'.
Choose the new default valve and depress the
•
timer switch for that valve three times, the display
will change to show the new selection, for
example 'Ehr1'.
Turn the key--start off, the new default valve for
•
front linkage operation is now memorised.
NOTE: For programming procedures on EHR
remote valves, see page 3- -66.

With twin spool mid mounted remote valve:

(where fitted)
The optional mid mount remote valve is controlled by
a joystick located on the right--hand side of the seat.
The mid mount valve provides two additional double
acting services, one of which may be utilised to
operate the front hitch.
Pull the joystick rearwards (R) to raise the
implement. When the hydraulic lift reaches the
height set by the height limit rotary control the
joystick will return automatically to neutral (N).
Alternatively, the hydraulic lift will stop raising when
the joystick is manually returned to the neutral
position. Moving the joystick fully rearward against
spring pressure will provide a faster rate of lift.
Pushing the joystick forward to the 'lower' position (L)
will cause the implement to lower to the ground at a
controlled rate of descent.
Further forward movement of the joystick will select
'float' (F) which will allow the cylinder to extend or
retract freely. When in the float position, pushing the
joystick fully forward against spring pressure will
slow the movement of the cylinder.
NOTE: Always use the 'float' position to lower a
single- -acting cylinder. The 'lower' position is for
double- -acting cylinders only.
3--36
SECTION 3 - - FIELD OPERATION
54
55