Wheels With Steel Centre Disc Welded To Flange On The Rim - New Holland T6010 Operator's Manual

Track Adjustment
1524 -- 2133 mm (72 -- 84 in.)
1625 -- 2235 mm (64 -- 88 in.)

Wheels with steel centre disc welded to flange on the rim

NOTE: The track widths in Figure 230 are nominal
and may vary from that shown dependent on wheel
and tyre size.
NOTE: With the larger width tyres, it may not be
possible to move the wheels to the narrower settings
due to limited clearance between the tyre and fender.
CAUTION
Tractor wheels are very heavy. Handle with care and
ensure, when stored, that they cannot topple and
cause injury.
WARNING
Never operate the tractor with a loose wheel rim or
disc. Always tighten nuts to the specified torque and
at the recommended intervals.
3--134
SECTION 3 - - FIELD OPERATION
Rim and Disc Position
When refitting or adjusting a wheel, tighten the bolts
to the following torques then re-check after 50 hours
of operation and thereafter as required.
IMPORTANT: When
right- -hand wheel assemblies, ensure the "V" of the
tread at the top of the tyre remains pointing in the
direction of forward travel.
Disc to hub nuts
8 Stud, steel disc wheels
Disc to rim nuts
Steel disc wheels
M16 nuts
230
interchanging left and
260 Nm (190 lbf. ft.)
240 Nm (177 lbf. ft.)