Setting The Maximum Flow Rate - New Holland T6010 Operator's Manual

Setting the Maximum Flow Rate

The maximum flow rate for each remote valve can be
set using the menu keys on the Enhanced keypad.
To adjust the remote valve flow rate, the key--start
must be switched ON.
Using the remote valve key (1), select the
appropriate valve (1, 2, 3, or 4).
With the selected valve number displayed in the
DMD, Use the MENU UP/DOWN keys (1 and 2), to
increase or decrease the maximum flow rate of the
selected valve. The flow rate will be stored in the
tractor control module until re--programmed, turning
the key--start off will not erase the setting.
NOTE: The remote valve flow rate setting (1),
Figure 126, will apply to both extend and retract
movements of the cylinder.
IMPORTANT: During remote valve set- -up, a pause
of more than two seconds in key operation will exit
set- -up and return to the previous setting, re- -enter
set- -up mode again to continue.
SECTION 3 - - FIELD OPERATION
1
2
124
125
126
3--71