Change 4Wd Planetary Hub Oil; Change Front Pto Gearbox Oil - New Holland T6010 Operator's Manual

OPERATION 27

CHANGE 4WD PLANETARY HUB OIL

Park the tractor on level ground and engage the park
brake.
To change the oil:
1. Positon the wheel so the filler/drain/level plug (1)
is at the lowest point . Remove the plug and
completely drain all oil into a suitable container.
Dispose of oil properly.
2. Rotate the wheel so that the combined level/filler
plug (1) is at the 3 o'clock position, as shown.
3. Refill the hub with new oil until it reaches the
bottom of the level/filler plug hole . Install the
plug.
4. Repeat the process on the other hub.
See page 4--9 for the correct oil specification.
Oil Capacity (each hub):
All axles without brakes
Standard and Suspended axles
with brakes
OPERATION 28
CHANGE FRONT P.T.O. GEARBOX OIL
Park the tractor on level ground and engage the park
brake.
1. Place a suitable container below the gearbox and
remove the level plug (1) and drain plug (2). Allow
the oil to completely drain into the container and
replace the plug (2). Dispose of oil properly.
2. Refill the gearbox through the combined
level/filler plug until the oil reaches the bottom of
the opening.
The oil quantity to refill the gearbox is approximately
400 ml. (13.5 U.S. oz.).
See page 4--9 for the correct oil specification.
SECTION 4 - - LUBRICATION AND MAINTENANCE
1.5 litres
(1.3 U.S. qts)
3.0 litres
(3.2 U.S. qts)
1
87
88
4--41