New Holland T6010 Operator's Manual page 85

SECTION 2 - - CONTROLS, INSTRUMENTS AND OPERATION
ENHANCED KEYPAD and
PERFORMANCE MONITOR (continued)
9. Linkage Height Position (C). Depress once to
display the rear linkage height, press again and
hold for 3 seconds to show front linkage height
(where fitted). The display will show a figure
between '0' (fully lowered) and '100' (maximum
raised position).
10. Exit/Cancel (D). Use this key to Exit or cancel
set--up and programming modes.
11. Menu Scroll Down or Digit Select (D). Depress
this key to scroll downwards through the menu or
select an alternative digit in the Dot Matrix
Display.
12. Battery Voltage (D). With the engine running,
touch the key to display the battery symbol
together with a digital display of the battery
voltage.
13. Trailer Brake Air Pressure (D). Depress to
display the trailer brake air pressure bargraph.
14. Area Accumulator (D). The total area worked will
be displayed in hectares or acres depending on
the ground speed unit selected.
15. Area Per Hour Forecaster (D). Touch this key
and the area/hour symbol will display together
with a forecast of the area that will be worked in
one hour if the current rate of work is continued.
NOTE: If the radar option is not installed, area per
hour calculations are based on axle speed and are
subject to inaccuracies caused by any wheel slip that
may occur.
16. Remote Valve Operation (D). The display will
show the flow rate through each valve as a
percentage (%), the direction of cylinder
movement (extend or retract) and the number of
the valve selected. (See Electronic Remote
Control Valves in Section 3).
101
2--57