Filling The Fuel Tank; Fuel Filler Cap; Fuel Capacity; Guards; Engine Hood - New Holland T6010 Operator's Manual

FILLING THE FUEL TANK

1. Clean the area around the fuel filler cap (1) to
prevent dirt from
contaminating the fuel .
2. Remove the cap and place in a clean area during
refuelling. The cap is attached to the fuel tank by
a chain to prevent loss.
3. After filling the tank, replace and tighten the fuel
cap.

Fuel filler cap

The fuel filler cap on your tractor is of the vented type,
should it become lost or damaged always replace it
with one of the same type. Consult your authorised
dealer.

Fuel Capacity

T6010, T6020
Standard
With SuperSteer
T6030 ,T6050, T6070
Standard
With SuperSteer
GUARDS
ENGINE HOOD
For safety the hood must be closed and correctly
latched before operating the tractor.
Additional guards are provided to prevent the fingers
being trapped by the fan/air conditioner drive belt
when the hood is lowered to the operating position.
The hood is hinged at the rear to provide easy access
to the engine area for routine maintenance. Two gas
struts (located under the hood) assist in raising the
hood to either of two positions. A safety stay holds
the hood in the selected position.
To open the hood, lift the release handle (1), Figure
3. The gas struts will take over and raise the hood
to the first position secured by the nylon retaining
strap located at the front of the hood. All routine
maintenance operations may be performed with the
hood raised to this position.
SECTION 4 - - LUBRICATION AND MAINTENANCE
entering tank
180 litres (47.5 U.S. galls)
156 litres (41.2 U.S. galls)
254 litres (67.0 U.S. galls)
236 litres (62.3 U.S. galls)
and
1
2
3
4--5