Ignition System; Winding; Checking The Spark Plug Connector; Alternator - Checking Stator Winding - Husqvarna FC 350 2014 Repair Manual

21

IGNITION SYSTEM

21.1 Ignition coil - checking the seconds
21.2

Checking the spark plug connector

2
21.3

Alternator - checking stator winding

Stator winding - check the short circuit to ground (terminal 31}
Measure the resistance between the specified points.
Alternator, connector
I
Resistance
If the displayed value does meet specifications:
- Change the stator.
Condition
Ignition coil cylinder 1 is disconnected.
Spark plug connector cylinder 1 has been removed.
Ignition coil cylinder 1 - check the secondary winding resistance
Measure the resistance between the specified points.
0
Ignition coil cylinder 1 pin 2 (-) - Ignition coil cylinder 1 pin 3
Ignition coil
Secondary winding resistance at:
20 °C (68 °F)
If the displayed value does not correspond to specifications:
- Change the ignition coil.
601750-10
Condition
Spark plug connector cylinder 1 has been removed.
Measure the resistance between the specified points.
Measuring point 1 - Measuring point 2
Spark plug connector
1
Resistance at: 20 °c (68 °F)
If the specification is not reached:
- Change the spark plug connector.
601170-10
Condition
The alternator is disconnected.
Stator winding - checking the resistance
Measure the resistance between the specified points.
0
Alternator, connector
Alternator
Resistance of stator winding at:
20 °C (68 °F)
If the displayed value does meet specifications:
- Change the stator.
pin - Measuring point
CR 1 Ground

winding

pin - Alternator, connector
CR 1
(-)
11.075 ... 15.525 kn
1
3.75 ... 6.25 kn
pin
CR
1.19 ... 1.61n
1
199
1