Installing intermediate flange
1100
Installing freewheel
•
Oil the needle roller bearing well.
•
Insert the freewheel into the crankcase with the
helical-cut gear leading.
Installing countershaft
e
Important:
Insert the spring so that the large external diameter
(arrow) projects upwards and is pre-loaded against
the freewheel gear.
•
Insert the countershaft into the crankcase with
the small gearwheel facing down.
11.38
Installing intermediate flange
•
Check that sealing face is clean and degreased
and apply a thin coat of Omni VISC 1002, see
line on sealing face with grey shading.
•
Fill the expansion groove (arrow) with sealing
compound.
KR110690
L
Note:
Scrape off excess sealant with a spatula.
•
Install the intermediate flange (with locating
sleeves).
•
Use Torx socket T 30, BMW No. 00 2 600, to
tighten the screws.
X
Tightening torque:
Intermediate flange......................................... 9 Nm
Installing output shaft sealing ring
L
Note:
Clean the sealing ring seat. Oil the sealing ring and
push it over the guide first.
•
Drive in shaft sealing ring with drift,
BMW No. 11 1 630, and handle,
BMW No. 00 5 500.
KL110270