2
1
Disassembling/assembling inter-
1100
mediate flange
Removing the driver bearing
•
Remove thrust plate (1).
•
Take off cup spring (2).
•
Remove ball bearing (3) with puller,
BMW No. 00 8 570, and internal puller 21/3,
BMW No. 00 8 574.
•
Remove snap ring (4).
Installing driver bearing
•
Install the snap ring (4).
L
Note:
Use temperature measuring device,
BMW No. 00 1 900, to check heat rise.
•
Heat the intermediate flange at the bearing seat
to approx. 120 °C (248 °F).
•
Press the ball bearing on as far as the snap ring.
4
3
•
Insert the cup spring with the larger diameter fac-
ing the bearing.
•
Install the thrust plate with the large cutout at the
top.
X
Tightening torque:
Thrust plate to intermediate flange
(clean thread + apply Loctite 243) .................. 9 Nm
KR110120
KR110130
11.29