BMW k 1200 rs Repair Manual page 320

•
Disconnect brake lines (arrows) from ABS pres-
sure modulator.
L
Note:
Always replace the seals (arrow) between the brake
lines and the pressure modulator when you replace
the brake lines.
d
Warning:
Always replace the springs. Ensure correct position-
ing.
•
Fit new springs.
•
Clip in brake lines.
•
Ensure that the springs are correctly seated on
both sides.
e
Attention:
Replace the sealing rings of the brake line/hose.
– Filling and bleeding the front brake system
( 34.17).
a
•
Check the operation of the brake system.
e
Attention:
After all the work on the brake system has been
completed, run a bleed test using the
BMW MoDiTeC!
•
Perform bleed test with BMW MoDiTeC
( 00.35).
a
Brake fluid....................................................DOT 4
X
Tightening torque:
Brake hose/line/banjo bolt ........................... 18 Nm
Brake fluid distributor to holder ...................... 9 Nm
Holder to sliding tube ..................................... 4 Nm
(clean thread + Loctite 243)
Bleed screw to brake caliper .......................... 7 Nm
34.26
KL340370