Installing Intermediate Flange; Installing Driver; Installing Alternator - BMW K 1100 LT/RS Repair Manual

Installing intermediate flange

Installing freewheel
Insert the freewheel into the crankcase with the
•
helical-cut gearwheel leading.
Oil the needle roller bearing well.
•
Installing countershaft
2
Insert countershaft (1) into the crankcase with
•
the small gearwheel facing downwards.
Insert spring (2) with the larger external
•
diameter (arrow) projecting upwards and located
behind the freewheel gear.
Installing intermediate flange
Apply a thin coat of 3-Bond 1209 to the sealing
•
faces, which must be free from oil and grease.
Attach the intermediate flange (with all collets in
•
position).
Tighten screws with Torx insert,
•
BMW No. 00 2 600.
X
Tightening torque:
Intermediate flange......................................... 9 Nm
L
Note:
Note rubber filler in the starter motor area.
11.46

Installing driver

Clean tapped hole and screw (must be free from
•
grease).
Push driver on to layshaft.
•
Secure retaining screw with Loctite 273 FL.
•
X
Tightening torque:
Driver ........................................................... 33 Nm

Installing alternator

Install the alternator with the damping rubber.
•
X
Tightening torque:
Alternator ..................................................... 22 Nm
1
LT110690