4
1
2
3
7
Removing, disassembling, reas-
33 17
sembling and installing rear
swinging arm
Removing rear swinging arm
33 17
–
Remove rear wheel (
a
–
[Without Integral ABS] Remove inductive signal
transmitter (
61.15).
a
–
Remove brake caliper and fasten to the rear
frame using a cable tie (
–
Remove rear wheel drive unit (
•
Loosen the right rear footrest plate.
e
Important:
Note high loosening torque at lock ring and left/right
threaded rings and bearing studs.
•
Remove circlip (1) and use socket wrench adapt-
er, BMW No. 33 6 643, to unscrew the right
threaded ring (6).
•
Remove circlip (1) and loosen lock ring (2)
5
7
8
36.8).
34.5).
a
33.7).
a
33 6 643
e
Important:
Note high loosening torque for lock ring and for the
threaded rings and the bearing studs on left and
right.
•
Loosen the left threaded ring (3) with socket
wrench insert, BMW No. 33 6 641.
•
Loosen bearing studs (5) at left and right.
•
Remove fastener (7) for shock absorber and
press the shock absorber upwards.
•
Remove left and right bearing studs (5).
•
Pull swinging arm (8) away from drive shaft.
5
6
1
4
KR330330
KR330410
33.21