BMW k 1200 rs Repair Manual page 350

Removing/installing fairing car-
46 63
rier
– Remove windscreen (
a
– Remove left/right inner trim panels
( 46.8).
a
– Remove upper section of fairing (
– Remove instrument-panel trim (
– Remove side panels (
a
– Remove headlight (
a
– Remove the air inlet guide (
– Remove the intake air pipe (
•
Disconnect oil cooler lines from oil cooler and re-
move oil cooler.
•
Disconnect plug for horn.
•
Disconnect plug for cruise control.
•
Release the instrument cluster from the fairing
holder.
e
Important:
Comply with safety regulations; fuel lines are pres-
surised.
– Remove fuel tank (
a
46.16
46.11).
46.9).
a
46.13).
a
46.10).
63.5).
46.17).
a
46.17).
a
16.5).
•
Release the cable ties, guide the instrument
cluster with wiring harness through the fairing
carrier and set it down on the frame.
•
Detach the radiators at left and right from their
holders and press forwards.
•
Release the fairing carrier and pull off forwards.
•
Remove windscreen holder and horn.
•
Remove cruise-control unit with holder.
•
Remove mounted parts.
•
Installation is the reverse of the removal proce-
dure.
X
Tightening torque:
Fairing carrier:
Left and right to frame .................................. 30 Nm
Centre to frame ............................................ 24 Nm
Instrument panel ............................................ 6 Nm
Oil cooler lines to oil cooler .......................... 25 Nm
Oil cooler to fairing carrier .............................. 9 Nm
KR460180