Removing Intermediate Flange - BMW k 1200 rs Repair Manual

3
2
1
Removing clutch housing
e
Important:
After unscrewing nut (1), do not strike the output
shaft or turn the engine over, so that output shaft
endplay cannot cause damage to the crankcase or
pump housing.
•
Unscrew nut (1) and take off thrust ring (2).
•
Move the clutch housing to and fro until O-
ring (3) is accessible, then remove it.
e
Important:
Do not lever the puller against the stub shaft.
•
Pull off clutch housing (4), noting the presence of
thrust washer (5).
11.28
4
5

Removing intermediate flange

•
Use Torx socket T30, BMW No. 00 2 600, to re-
lease the screws.
•
Remove the intermediate flange.
KR110090