Supporting the frame
46 00
46 5 660
L
Note:
For supporting the frame with front-wheel guide for
the following tasks:
–
Gearbox removal
–
Engine removal
1
–
Remove rear swinging arm.
–
Remove universal shaft.
–
Remove transverse tube (
•
Secure frame support, BMW No. 46 5 660, to
the mounting points (1) for the transverse tube.
•
Installation is the reverse of the removal proce-
dure.
46.34
46 51
threaded bushes for swinging-arm
pivot
Removing threaded bushes
L
The right and left threaded bushes are not identical.
•
d
Always wear protective gloves when handling heat-
ed parts in order to avoid burns.
K41460170
e
When applying heat, always take care not to dam-
age cables and lines and rubber and plastic compo-
nents.
46 5 660
K41460180
•
•
46.25).
a
•
•
Removing/installing right and left
Note:
Remove rear swinging arm (
Warning:
Important:
46 5 735
Using a hot-air gun, heat the frame to approx.
100 °C (212 °F).
Use BMW refrigerant spray to chill the threaded
bush.
Drive out the threaded bush using handle for
drift, BMW No. 00 5 500 and drift,
BMW No. 46 5 735.
Clean the seat in the frame.
33.21).
a
h
100
00 5 500
KL460440