10
•
Loosen pressure modulator.
•
Apply masking tape to left side of rear frame.
e
Attention:
Do not bend the piping system on removal.
•
Pull pressure modulator to the left to remove,
complete with brake lines and hoses.
•
If necessary, remove sealing rings from brake
lines.
e
Attention:
The pressure modulator contains brake fluid.
•
Set down the pressure modulator with the con-
nections upwards.
34.14
4
3
2
1
•
Installation is the reverse of the removal proce-
dure. Pay particular attention to the following:
L
Note:
Always replace the seals (arrow) between the brake
lines and the pressure modulator when you replace
the pressure modulator or brake lines.
d
Warning:
Always replace the springs (10).
Ensure correct positioning.
•
Install 3 new springs (10).
•
Clip brake lines (1-4) into position.
•
Ensure that the springs (10) are correctly seated
KR340740
on both sides.
•
Install protective caps (9).
–
Fill the brake system (
8
9
7
6
5
KR340752
34.17).
a