6
Removing/installing clutch
32 72
lever fitting
–
Take off mirror (
00.22).
a
–
Remove grip tube (
32.5).
a
e
Important:
Do not allow brake fluid to come into contact with
painted parts of the motorcycle, because brake fluid
destroys paint.
–
Drain the clutch operating system (
•
Disconnect clutch line (2) from clutch lever
fitting (1).
•
Detach multifunction switch (4) from clutch lever
fitting (1).
•
Remove cover (5) from clutch lever fitting (1).
•
Remove clutch switch (6) from clutch lever
fitting (1).
•
Loosen fastener (arrow) for clutch lever fitting (1)
on handlebar tube (3).
•
Pull clutch lever fitting (1) off handlebar tube (3).
1
2
5
00.62).
a
3
4
•
Installation is the reverse of the removal proce-
dure. Pay particular attention to the following:
e
Important:
Make sure that lines and cables are correctly routed.
L
Note:
Note correct installed position of clutch switch (6).
•
The marks on the clutch lever fitting (1) and han-
dlebar tube (3) must be aligned (arrow).
•
Tighten the clutch lever fitting (1).
–
Add brake fluid and bleed
(
00.62).
a
X
Tightening torque:
Fastener for clutch lever fitting ....................... 6 Nm
Line to fitting ................................................ 18 Nm
Mirror ........................................................... 20 Nm
K41320010
32.7