[Integral Abs] Filling Control Circuit; Filling The Front Control Circuit; Bleeding Front Control Circuit ( A 00.52) - BMW k 1200 rs Repair Manual

[Integral ABS] Filling control
3400
circuit
L
Note:
Only check the brake system after bleeding of all
brake circuits.
e
Attention:
Do not allow brake fluid to come into contact with
painted parts of the motorcycle, because brake fluid
destroys paint.
e
Attention:
Do not disconnect the connector from the ABS con-
trol unit.

Filling the front control circuit

MAX
e
Attention:
When adding brake fluid, do not allow it to enter the
holes for the reservoir lid screws.
•
Top up the reservoir to the MAX mark.
e
Attention:
During the filling process, ensure that the return
bore (arrow) is always covered with brake fluid as
otherwise air is drawn into the brake system.
Bleed the control circuit again if this happens.
–
•
•
•
Bleeding front control circuit (
MIN
KR340640
Connect the silicon hose with bleeding device to
each of the 3 bleed screws in turn,
- front dosing cylinder
- front integral circuit
- front control circuit
Let the brake fluid run out and, at the same time,
continuously top up with new brake fluid in the
control-circuit reservoir.
Let brake fluid run off until it emerges clear and
free of air bubbles.
Close the bleed screw.
00.52)
a
34.19