D-Link DES-1228/ME Reference Manual page 198

show 802.1x
Purpose Used to display the current authentication state and authentication configuration of the 802.1X
server on the Switch.
Syntax show 802.1x [auth_state | auth_configuration] {ports <portlist>}
Description This command is used to display the current configuration or authentication state of the 802.1X
server on the Switch.
Parameters
auth_state – Displays the current authentication state of the 802.1X server.
auth_configuration – Displays the current authentication configuration of the 802.1X server.
ports <portlist> − Specifies a port or range of ports to view.
The following details are displayed for the authentication configuration:
802.1x Enabled / Disabled − Shows the current status of 802.1X functions on the Switch.
Authentication Mode – Shows the authentication mode, whether it be by MAC address or by
port.
Authentication Protocol − Shows the authentication protocol suite in use between the Switch
and a RADIUS server. May read Radius_Eap or local.
Port number − Shows the physical port number on the Switch.
Capability: Authenticator/None − Shows the capability of 802.1X functions on the port number
displayed above. There are two 802.1X capabilities that can be set on the Switch: Authenticator
and None.
AdminCtlDir: Both / In − Shows whether a controlled Port that is unauthorized will exert control
over communication in both receiving and transmitting directions, or just the receiving direction.
OpenCtlDir: Both / In − Shows whether a controlled Port that is unauthorized will exert control
over communication in both receiving and transmitting directions, or just the receiving direction.
Port Control: ForceAuth / ForceUnauth / Auto − Shows the administrative control over the port's
authorization status. ForceAuth forces the Authenticator of the port to become Authorized.
ForceUnauth forces the port to become Unauthorized.
QuietPeriod − This is the initialization value of the quiet period timer. The default value is 60s
and can be any value between 0-65535.
TxPeriod − This us the initialization value of the tx timer. The default value is 30s and can be
any value between 1-65535.
SuppTimeout − Shows the time to wait for a response from a supplicant (user) for all EAP
packets, except for the Request / Identity packets.
ServerTimeout − Shows the length of time to wait for a response from a RADIUS server.
MaxReq − Shows the maximum number of times to retry sending packets to the supplicant.
ReAuthPeriod − Shows the time interval between successive re-authentications.
ReAuthenticate: Enabled / Disabled − Shows whether or not to re-authenticate.
The following details are displayed for the current authentication state:
Port number − Shows the physical port number on the Switch.
Auth PAE State: Initalize / Disconnected / Connecting / Authenticating / Authenticated / Held /
ForceAuth / ForceUnauth − Shows the current state of the Authenticator PAE.
Backend State: Request / Response / Fail / Idle / Initalize / Success / Timeout − Shows the
current state of the Backend Authenticator.
Port Status: Authorized / Unauthorized − Shows the result of the authentication process.
Authorized means that the user was authenticated, and can access the network. Unauthorized
means that the user was not authenticated, and cannot access the network
Restrictions None.
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
194