D-Link DES-1228/ME Reference Manual page 254

Example usage:
To disable MAC notification without changing basic configuration:
DES-1228/ME:5#disable mac_notification
Command: disable mac_notification
Success.
DES-1228/ME:5#
config mac_notification
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the Switch's MAC address table notification global settings:
DES-1228/ME:5#config mac_notification interval 1 historysize 500
Command: config mac_notification interval 1 historysize 500
Success.
DES-1228/ME:5#
config mac_notification ports
Purpose
Syntax
Description
Parameters
Restrictions
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Used to configure MAC address notification.
config mac_notification {interval <int 1-2147483647> | historysize
<int 1-500>} (1)
This command is used to monitor MAC addresses learned and
entered into the FDB.
interval <int 1-2147483647> − The time in seconds between
notifications. The user may choose an interval between 1 and
2147483647 seconds.
historysize <1-500> − The maximum number of entries listed in the
history log used for notification.
Only Administrator level, Operator level or Power User level users
can issue this command.
Used to configure MAC address notification status settings.
config mac_notification ports [<portlist> | all] [enable | disable]
This command is used to monitor MAC addresses learned and entered
into the FDB.
<portlist> − Specifies a port or range of ports to be configured.
all – Entering this command will set all ports on the system.
[enable | disable] – These commands will enable or disable MAC
address table notification on the Switch.
Only Administrator level, Operator level or Power User level users can
issue this command.
250