D-Link DES-1228/ME Reference Manual page 277

Example usage:
To view authentication server groups currently set on the Switch.
DES-1228/ME:5#show authen server_group
Command: show authen server_group
Group Name
-----------
radius
tacacs
tacacs+
xtacacs
Total Entries : 4
DES-1228/ME:5#
config authen parameter response_timeout
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the response timeout for 60 seconds:
DES-1228/ME:5#config authen parameter response_timeout 60
Command: config authen parameter response_timeout 60
Success.
DES-1228/ME:5#
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
IP Address
-----------------------------
---------------------------------------------
---------------------------------------------
---------------------------------------------
---------------------------------------------
Used to configure the amount of time the Switch will wait for a user to
enter authentication before timing out.
config authen parameter response_timeout <int 0-255>
This command is used to set the time the Switch will wait for a response
of authentication from the user.
response_timeout <int 0-255> − Set the time, in seconds, the Switch will
wait for a response of authentication from the user attempting to log in
from the command line interface or telnet interface. 0 means there won't
be a time-out. The default value is 30 seconds.
Only Administrator level users can issue this command.
Protocol
------------
273