Wichtige Sicherheitshinweise Bitte lesen Sie sich diese Hinweise sorgfältig durch. Heben Sie diese Anleitung für den spätern Gebrauch auf. Vor jedem Reinigen ist das Gerät vom Stromnetz zu trennen. Vervenden Sie keine Flüssig- oder Aerosolreiniger. Am besten dient ein angefeuchtetes Tuch zur Reinigung. Um eine Beschädigung des Gerätes zu vermeiden sollten Sie nur Zubehörteile verwenden, die vom Hersteller zugelassen sind.
This Warranty applies on the condition that the product Registration Card is filled out and returned to a D-Link office within ninety (90) days of purchase. A list of D-Link offices is provided at the back of this manual, together with a copy of the Registration Card.
D-Link Offices for Registration and Warranty Service The product's Registration Card, provided at the back of this manual, must be sent to a D-Link office. To obtain an RMA number for warranty service as to a hardware product, or to obtain warranty service as to a software product, contact the D-Link office nearest you.
LIGHTNING OR OTHER HAZARD. Limitation of Liability IN NO EVENT WILL D-LINK BE LIABLE FOR ANY DAMAGES, INCLUDING LOSS OF DATA, LOSS OF PROFITS, COST OF COVER OR OTHER INCIDENTAL, CONSEQUENTIAL OR INDIRECT DAMAGES ARISING OUT THE INSTALLATION, MAINTENANCE, USE, PERFORMANCE, FAILURE OR INTERRUPTION OF A D- LINK PRODUCT, HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY.
Page 6
Dies ist ein Produkt der Klasse A. Im Wohnbereich kann dieses Produkt Funkstoerungen verursachen. In diesem Fall kann vom Benutzer verlangt werden, angemessene Massnahmen zu ergreifen. Precaución! Este es un producto de Clase A. En un entorno doméstico, puede causar interferencias de radio, en cuyo case, puede requerirse al usuario para que adopte las medidas adecuadas.
Page 7
10/100 Fast Ethernet Switch User’s Guide EATURES 16 or 24 UTP ports all come with NWay auto-negotiation and operate at 10/100 Mbps for connection to servers and hubs. All ports can auto-negotiate for full or half-duplex operation. All ports support auto MDI/MDIX, so there is no need to use cross- over cables or an up-link port.
Page 8
10/100 Fast Ethernet Switch User’s Guide full duplex or half duplex by means of a manual setting. Please see Chapter Two for additional information about module settings.
Page 9
Four rubber feet with adhesive backing Screws and two L-type brackets for rack mounting If any item is found missing or damaged, please contact your local D-Link reseller for replacement. Setup The setup of the Switch can be performed using the following steps: The surface must support at least 3 kg for the Switch.
10/100 Fast Ethernet Switch User’s Guide Desktop or Shelf Installation When installing the Switch on a desktop or shelf, the rubber feet included with the device must be first attached. Attach these cushioning feet on the bottom at each corner of the device. Allow enough ventilation space between the device and the objects around it.
10/100 Fast Ethernet Switch User’s Guide Figure 2.2 Attaching the mounting brackets to the 10/100 Fast Ethernet Switch Then, use the screws provided with the equipment rack to mount the Switch in the rack. Module Installation An optional two-port fiber module (SC type connector) can be installed in the front panel.
Page 12
10/100 Fast Ethernet Switch User’s Guide Next, make sure that the device is powered off and then remove the plain bracket on the front of the switch. Figure 2.4 Removing the plain bracket After removing the plain bracket, slide the module in the guide rails all the way into the slot and secure the screws.
10/100 Fast Ethernet Switch User’s Guide DENTIFYING XTERNAL OMPONENTS Front Panel The front panel of the Switch consists of 16 (DES-1016R+) or 24 (DES-1024R+) 10/100 Mbps MDI-II/MDI-X ports and LED indicators. Figure 3.1 Front panel view of the DES-1024R+ Switch Rear Panel The rear panel of the Switch consists of an AC power connector.
10/100 Fast Ethernet Switch User’s Guide LED Indicators The LED indicators of the Switch include Power, 100M, Link/Act (Link/Activity), and Slot. The LED indicators are used to facilitate monitoring and troubleshooting of the Switch. The following shows the LED indicators for the Switch along with an explanation of each indicator.
ECHNICAL PECIFICATIONS General Network Cabling: 10BASE-T: 2-pair UTP Cat. 3, 4, 5 (100m) EIA/TIA- 568 100-ohm STP (100m) 100BASE-TX: 2-pair UTP Cat. 5 (100m) EIA/TIA-568 100-ohm STP (100m) 100BASE-FX: Multi-mode (62.5/125µm or 50/125µm fiber cabling with SC connector Number of Ports: DES-1016R+: 16 x 10/100 Mbps ports DES-1024R+: 24 x 10/100 Mbps ports DES-102F: 2 x 100BASE-FX ports...
Page 16
DC Fan: One built-in 40 x 40 x 10 mm DC fan Dimensions: 441 x 207 x 44 mm (IU), 19-inch rack-mount width Weight: DES-1016R+: 2.6 kg & DES-1024R+: 2.7 kg...
Page 17
TEL: 39-02-2900-0676 FAX: 39-02-2900-1723 URL: www.dlink.it E-MAIL: info@dlink.it JAPAN D-LINK TOKYO 10F, 8-8-15 Nishi-Gotanda, Shinagawa -ku, Tokyo 141 Japan TEL: 81-3-5434-9678 FAX: 81-3-5434-9868 URL: www.d-link.co.jp E-MAIL: kida@d-link.co.jp SINGAPORE D-LINK INTERNATIONAL/D -LINK SINGAPORE 1 International Business Park, #03-12 The Synergy, Singapore 609917 TEL : 65-774-6233 FAX: 65-774-6322 E-MAIL: info@dlink.com.sg...
8. What category best describes your company? oAerospace oEngineering oEducation oFinance oHospital oLegal oInsurance/Real Estate oManufacturing oRetail/Chainstore/Wholesale oGovernment oTransportation/Utilities/Communication oVAR oSystem house/company oOther________________________________ 9. Would you recommend your D-Link product to a friend? oYes oNo oDon't know yet 10.Your comments on this product? __________________________________________________________________________________________...