Basic Ip Commands - D-Link DES-1228/ME Reference Manual

The Basic IP interface commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command
config ipif
show ipif
enable autoconfig*
disable autoconfig
delete ipif
enable
ipif_ipv6_link_local_auto
disable
ipif_ipv6_link_local_auto
show
ipif_ipv6_link_local_auto
Each command is listed, in detail, in the following sections:
*See Switch Utility Commands for descriptions of all autoconfig commands.
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameters
[System] [{ ipaddress <network_address> | vlan <vlan_name
32> | state [enable|disable]} | bootp | dhcp | dhcp_option12
[hostname
[enable|disable]] | ipv6 ipv6address <ipv6networkaddr>]
[System] [ipv6adress <ipv6networkaddr>]
[System]
[System]
B
<hostname 63>| clear_hostname
165
IP C
ASIC OMMANDS
| state
18