Bpdu Attack Protection Commands - D-Link DES-1228/ME Reference Manual

The BPDU Attack Protection commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command
config bpdu_protection ports
config bpdu_protection recovery_timer
config bpdu_protection
enable bpdu_protection
disable bpdu_protection
show bpdu_protection
Each command is listed, in detail, in the following sections:
Note: The BPDU Attack Protection function and Spanning Tree Protocol for ports are mutually
exclusive. When the STP function is enabled on a particular port, BPDU Attack Protection cannot be
enabled. If BPDU Attack Protection function is enabled on a port, BPDU cannot be forwarded.
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
BPDU A
Parameters
[<portlist> | all ] {state [enable | disable] | mode [ drop | block |
shutdown } (1)
[<sec 60-1000000> | infinite]
[ trap | log ] [ none | attack_detected | attack_cleared | both ]
{ ports {<portlist> } }
P
TTACK ROTECTION
367
47
C
OMMANDS