D-Link DES-1228/ME Reference Manual page 204

Example usage:
To initialize the authentication state machine of all ports:
DES-1228/ME:5# config 802.1x init port_based ports all
Command: config 802.1x init port_based ports all
Success.
DES-1228/ME:5#
config 802.1x reauth
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure 802.1X reauthentication for ports 1 to 18:
DES-1228/ME:5#config 802.1x reauth port_based ports 1-18
Command: config 802.1x reauth port_based ports 1-18
Success.
DES-1228/ME:5#
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Used to configure the 802.1X re-authentication feature of the Switch.
config 802.1x reauth [port_based ports [<portlist> | all] | mac_based |
ports [<portlist> | all] {mac_address <macaddr>}]
This command is used to re-authenticate a previously authenticated
device based on port number.
port_based – This instructs the Switch to re-authorize 802.1X functions
based only on the port number. Ports approved for re-authorization
can then be specified.
mac_based − This instructs the Switch to re-authorize 802.1X
functions based only on the port number or the MAC address. MAC
addresses approved for re-authorization can then be specified.
ports <portlist> − Specifies a port or range of ports to be re-authorized.
all − Specifies all of the ports on the Switch.
mac_address <macaddr> − Enter the MAC address to be re-
authorized.
Only Administrator level, Operator level or Power User level users can
issue this command.
200