Camshaft Installation - Honda 86-87 TA200 FATCAT Service Manual

Install the cylinder head.
Install the two 6 mm cap nuts, four washer and 8 mm nuts,
and t ighten them in the sequence shown in 2 or 3 steps.
TORQUE :
6 mm cap nut : 10 - 14 N-m 11 .0 - 1.4 kg-m, 7 - 10 It-fb)
8 mm nut: 28 - 30 N·m (2.8-3. 0 kg-m , 2 0 - 22 ft ·lb)
CAMSHAFT INSTALLATION
Turn the crankshaft counterclockwise slowly and align "T"
'mark on the flywheel with the Index mark on the left crankcase
cover.
CAUTION
When turning the crankshaft, make sure the C(Jm cham dol's
1101 j am chain tension!'r or crankshaft.
Lubricate the camshaft bearings with clean engine oil.
Place the camshaft on the cylinder head, align the index lines
on the cam sprocket with the top of the cylinder head and in-
stall the cam chain over the cam sprocket .
Install the camshaft bearing and tighten the holder bolts.
TORQUE : 10 - 14 N·m !1.0 - 1.4 kg -m , 7 - 10 ft-Ibl
NOTE
• Be careful not to drop foreign material into the crankcase.
CYLINDER HEAD/V ALVES
6-13