Centrifugal Clutch; Weight Lining Inspection - Honda 86-87 TA200 FATCAT Service Manual

Check the lifter cam plale for wear or damage.
Remove the O-ring from the adjusting screw if necessary.
Install the washers onto the kick starter drive gear and drive
gear shaft into the cover.
Install the holder with the needle bearing and tighten the bolts
securely.
Screw the clutch adjusting screw into the lifter cam plate and
install the O·ring onto the screw.
Install the clutch adjusting screw and lifter cam plate aligning
the lifter pin with the hole in the right crankcase cover.
Install the washer and lock nut.
Tighten the lock nut after installing the right crankcase cover
and adjusting the clutch
system.
CENTRIFUGAL CLUTCH
REMOVAL
Remove the centrifugal clutch cover.
WEIGHT LINING INSPECTION
Measure the weight lining thickness.
SERVICE LIMIT :
'86 1 .2
mm
(0.05 in)
After '86 2 .0
mm
10.08 in)
Replace the centrifugal weight assembly if the lining thickness
is worn beyond the service limit.
CLUTCH/KICK STARTER/GEARSHIFT LINKAGE
(3 ) WASHER
\
\)
,
\
(5) LOCK NUT
(4 ) O·RING
8-5