Rear Wheel Assembly; Rear Wheel Installation - Honda 86-87 TA200 FATCAT Service Manual

REAR WHEEL/BRAKE/SUSPENSION
ASSEMBLY
Install the brake drum in the reverse ord er 01 removal.
Inst all new lock washers and tighten the bolts .
TORQUE: 25 - 35 N·m 12. 5 - 3 .5 kg -m, 18 - 25
ft -fb l
Bend up the lock washer tabs against the boll head.
Install the rear wheel hub ont o the feaf wheel.
Tighten the wheel hub nuts.
T ORQUE: 60 - 70 N·m (6 .0 - 7 .0 kg -m , 43 - 5 1 it-fb i
Install the driven sprocket onto the hub.
Tighten Ihe driven sprocket nut.
TORQUE: 28 - 34 N·m (2.8-3.4
kg-m ,
20 - 25 ft- fbl
Apply grease to the inside of the dust seal and install it into the
hub.
Install the side collar.
INSTALLATION
Install the fear brake panel.
NOTE
• Refer to Section l ' for the rear tire removal /repair.
Align the groove on the brake panel with the lug on the swing
arm . Install the drive chain on the driven sprocket.
Apply thin coat of grease to the axle.
Install the rear wheel by inserting the axle wi t h chain adjust er
through from the right side.
12-6
111 LOCK
W~ ~H"A S
I
I
,
111
j