Drive Chain Slider; Brake Shoe Wear; Front Brake; Rear Brake - Honda 86-87 TA200 FATCAT Service Manual

MAINTENANCE
Inspect the sprocket teeth fo r excessive wear or damage. Ae -
place
if
necessary .
NOTE
Never install a new drive chain on worn sprockets or a worn
chain on new sprockets . Both chain and sprockets must be
in good condition, or the new replacement chain or sprock-
ets will wear rapidly.
IN STALLATION
Install the drive chain.
Install the master link with D-rings and chain retaining clip.
Note the installation direction of the chain retaining clip.
Its open end should face in the opposite direction of the wheel
rotation as shown.
Adjust the drive chain slack.
CAUTION
Do
nOf assemble the drive chain without the jour O-rings. Be
sure tha/lheN> is no space belwt't"n the master fink and chain re-
laining clip.
DRIVE CHAI N SLIDER
Remove the drive sprocket cover .
Inspect the chain slider for excessive wear .
SERVICE LIMIT: (from upper surface I: 3 mm 10 .1 Inl
Install the drive sprocket cover.
BRAKE SHOE WEAR
FRONT BRAKE
Replace the brake shoes if the indicator plate aligns with the
brake panel index mark when the ' ront brake lever is applied.
REAR BRAKE
Replace the brake shoes if the indicator plate aligns with the
brake panel index mark when the rear brake lever or pedal is
applied.
3-10
r
)(
ttl DAMAGE
o
D
(21 OUT SIDE
3mm I
o
)(
13) WEAR
o
(2, NORMAL
(4 ) RETAINING CLIP
(1 I M ASTER LINK
13) (NO SPACE)
(5) O-RINGS
SLIDER
~1
'''INDiCATOR PLATE
filii'
f
(2) INDEX MARK