Front Wheel Removal; Front Wheel Inspection - Honda 86-87 TA200 FATCAT Service Manual

Align the end of the throttle cover with the handlebar punch
mark and install the throttle grip housing.
Tighten the upper screw first, then tighten the lower screw.
Install the front brake bracket and holder on the handlebar with
the dot mark up.
A lign the end of holder with the handlebar punch mark.
Tighten the upper screw 'irst, and tighten the lower screw .
Install the wire bands securely.
NOTE
After installing the handlebar, check tha t the throttle grip
rotates freely in atl steering positions.
Perform the following inspections and adjustments;
- Throttle operation (page 3 -41
- Brake lever free -play (page 3-101
FRONT WHEEL
REM OVAL
Raise the front wheel off the ground by placing a box or
workstand under the engine.
Move the front wheel sideways with force to see if the hont
wheel bearings are worn.
Refer to page
11 -6
fo r front wheel bearing inspection and re-
placement.
Remove the front brake adjusting nut and disconnect the brake
cable from the brake arm.
Remove the 8)Cle nut, 8)Cle and front wheel.
Remove the brake panel from the f ront wheel.
Remove the a)Cle side collar from the wheel hub.
INSPECTION
Axle
Set the ade in
V
blocks and measure the runout.
SERVICE LIMIT : 0 .2 mm (0 .01 in l
FRONT WHEEU BRAKE/SUSPENSION/ STEERING
•
,
2l~:2:'lJSlrlNG
NUT
11-5