Carburetor Installation; Air Screw Adjustment - Honda 86-87 TA200 FATCAT Service Manual

FUEL SYSTEM
Assemble the carburetor top, throttle valve spring and throttle
valve, and connect the throttle cable to the throttle valve.
CARBURETOR INSTALLATION
Install the carburetor between the intake manifold.
Reconnect the connecting tube to the carburetor and tighten
the nuts and tube band screw securely.
Connect the drain and air vent tubes to the carburetor body.
Connect the choke cable to the choke arm, adjust the choke
cable and check the choke valve operation by pulling the choke
knob (page 3- 5).
NOTE
Route the throttle and choke cables and overflow and air
vent tubes properly _
Make sure that. the drain screw on the float chamber is lIght-
ened.
Align the throttle valve groove with the throttle stop screw,
and install the thranle valve into the carburetor and the carbu-
retor top onto the carburetor.
Install the fuel tank (page 4-3) .
Check the throttle operation (page 3-4\.
Adjust the carburetor idle speed (page 3-B\.
AIR SCREW ADJUSTMENT
NOTE
The air screw is factory pre-se t. Adjustment is not neces-
sary unless Ihe carburetor is overhauled or a new air screw
is installed.
CAUTION
Damage {O Ihe air screw seal will fXy.:ur
if
Ihe air screw is fighl-
ened againsl fhe seal.
1. Turn the air screw clockwise until it seats lightly and then
back it out to the specification.
AIR SCREW OPENING: t - t /4 turn s OUI
This is an initial selling prior
10
the final air screw adjust-
ment.
4 -10
I
(4) ATTACHING
""""'VO
CABLE CLAMP