Handlebar Removal; Handlebar Installation - Honda 86-87 TA200 FATCAT Service Manual

HANDLEBAR
REMOVAL
Remove the following:
- w ire bands
- throttle grip housing and disconnect the throttle cable from
the throttle pipe.
- front and rear brake lever holders and brackets.
- handlebar switch
- handlebar upper holders
- handlebar
INSTALLATION
If the left handlebar grip or throttle pipe from the right handle'
bar grip has been removed:
Apply Honda Bond A or Honda Hand Grip Cement (U.S.A.
only) 10 the inside surface of the grips and to the clean surface
of the left handlebar and throttle pipe.
Wait 3 - 5 minutes and install the grips. Rotate the grips for
even application of adhesive.
NOTE
• Allow the adhesive to dry for an hour before using.
Place the handlebar on the lower holders.
Align the handlebar punch mark with the top of the right
handlebar lower holders.
Install the handlebar
upper holders on the handlebar.
FRONT WHEEL/BRAKE/SUSPENSION/STEERING
111 REAR BRAKE
LEVER HOLDER
j
141 HA"DLE.',R
SWITCH
0)
LEFT
HANUC",'AH
GRIP
(2)
FRONT BRAKE
HOLDER
(5)
THROTTLE
GRIP
HOUSING
11-3