Left Crankcase Cover Installation - Honda 86-87 TA200 FATCAT Service Manual

ALTERNATOR/STARTER CLUTCH
Install the starter driven gear and starter idle gear shaft.
NOTE
Install the inner starter idle gear
i
17TI and the outer starter
idle gear (21 T) correctly. Incorrect engagement could
damage the gears.
Engage the inner gear teeth and the starter driven gear
teeth correctly at installation.
Make sure that the inside of the flywheel and crankshaft are
not contaminated . Clean
if
necessary.
Install the f lywheel onto the crankshaft, aligning the key way
in the lIywheel with the key on the crankshaft .
Install the flywheel bolt and hold the flywheel with the fly.
wheel holder .
TOO L:
Flywheel holder 07725 -0040000 or strap wrench commer-
cially available in U.S .A.
Tighten the flywheel bolt.
TORQUE: 45 - 55 N'm (4 .5-5.5 kg ·m . 33- 40 ft·lbl
LEFT CRANKCASE COVER INSTALLATION
Install the outer starter idle gear (21 teeth).
Install the dowel pins and a new gasket .
9-6
\.
(2) DOWEL