Ignition Switch Inspection; Ignition Switch Removal; Handlebar Switch; Engine Stop Switch - Honda 86-87 TA200 FATCAT Service Manual

LIGHTS/SWITCHES
IGNITION SWITCH
INSPECTION
Remove the headlight case mounting bolts.
Oisconnect the ignition switch wires (Green and Black/While)
and the 2P coupler IBlack and Redl.
Check the switch for continuity between the black / white and
green wires with the switch "OFF", and th e red and black
with the switch "ON" .
The switch is norm al if there is continuity between the circuits
marked " 0---0 ".
REMOVAL
Disconnect the Green and Black/While wire connectors and
the 2P coupler.
Push the lugs on th e ignition swit ch in and remove the ignition
switch from the headlight case.
HANDLEBAR SWITCH
NOTE
The handlebar switch (lighting, dimmer, engine stop, and
starter switches) must be replaced as an assembly.
Remove t he headlight case mounting bolts and disconnect the
4P coupler and the Black/ White wire.
Check for continuity between the terminals.
Continuity should exist between the color coded wire termi -
nals in each chart .
ENGINE STOP SWITCH
COLOR
G BIIW
OFF
0 0
RUN
LIGHTING/DIMMER SWITCHE S
SWI TCH LIGHTING DIMMER
COLOR
.,
.,
.0
Off HI C
ON INI
lo
INTERCONNECTIONS
17-4
;NITION SWITCH
•
STARTER SWITCH
COLOR
.,
. ~
W
RELEASED
PUSHED
-=--