Brake Panel Assembly - Honda 86-87 TA200 FATCAT Service Manual

FRONT WHEEL/BRAKE/SUSPENSION/STEERING
Remove the washer from the brake panel by bending up the
washer tab, if necessary .
Remove the brake arm, wear indicator plate, return spring and
brake cam.
Remove the dust
seal.
Check the dust seal for wear or damage and replace if neces-
sary.
BRAKE PANEL ASSEMBLY
Apply grease to the dust seal .
InSlall the dust seal onto the brake panel.
Apply silicone grease to the brake cam sliding surface and
anchor pin.
, it!
Wipt
txcess
grease off the cam. A contaminated brake lining
rl'lfllces stopping power. Keep grease off the lining.
Install the brake cam.
Install the return spring .
Place the wear indicator plate onlO the brake cam by aligning
lhe wide tooth on the plate with the wide groove on the brake
cam .
Install the brake arm with aligning the punch marks on the
brake cam and arm.
Torque the bolt.
TORQUE: 8 - 12 N'm (0.8 - 1.2
kg-m,
6 - 9
ft -Ibl
Install the washer and bend down the washer tabs.
11-14
SEAL
7-
(1)
WASHER
(1)
ANCHOR~
~I
BRAKE CAM
131 PU'I,H MARKS
121 REllURN
SPRING